|
|
 |
 |
|
Fire Alarm Systems to BS 5839
Typically:
Installation or Modification of a new or existing Fire Alarm
System.
From: Conventional Fire Alarms Systems where
detection devices are wired in zones, e.g. basement (zone 1),
ground floor (zone 2), and first floor (zone 3).
If a Smoke/Heat Detector or Call Point is activated the fire alarm
will activate. The panel will then indicate which zone has been
activated.
To: Analogue Fully Addressable Fire Alarm Systems
where detection devices are wired in loops incorporating zones.
Each device is given an address e.g. 25. When the commissioning is
complete the panel is programmed and each address is given a label,
so for example 25 would be "Manager’s Office". If that device
is activated then the fire alarm will activate and the panel will
display "FIRE - Manager’s Office".
Test and Commission, then provide Certification and Log Book for
the end user responsible for the management of Health and
Safety. |
|
